Trimble s6 radios not connecting
Hi all, i’ve a problem with my trimble s6 totale station, when i want to deal with robotic mode
First i configured radio settings in TS -channel and id- the same as in trimble cu,
After that i completly install my station and click on robotic mode, then i removed cu and place it in robotic radio holder global, and run cu again.
The problem is here…. When i want to mesure a point a small message apears saying: connecting to total station
And it still showing like that forever
So what i should do as solution
Here are some info about my hardwares:
Radio holder type: robotic holder global 58021019
Radio of total station: part no 58010019
TS firmware ver: R12.5.54
Trimble access prog version: 2015
Radio holder with cu in trimble radio settings prog in controle panal shows: radio info programe version 5.54
Sn: 48 19 21
But opening the same prog with total staion it show: not available in the two colmun
- Anything more info, please help..
Log in to reply.