Topcon Hiper V and Surv Ce
I have a topcon hiper v running surv ce 6.0 does anyone have a problem when the batteries die or you change them out on the base or rover. After I put a new battery in I get a fix again go stake a point and its off by a couple feet. I can go through the setup in carlson again and everything will be correct when the battery dies its losing the base location I guess and then if you don’t reset everything it will be off. I want to say it still does this even if the battery doesn’t go dead and I change them out. I have talked to carlson about this they say its a topcon problem but I have run the same units before in survey pro and never had this issue you don’t have to reconnect every time a batter dies or is changed. Could this be a setting on the receivers or a setting in carlson I am need to change.
Log in to reply.