Survey Pro 5.6.2 won't calibrate
I’m trying to calibrate to a file a firm sent me to stake some road centerline. They tell me the control point coordinates are a modified state plane where the initial point is a true state plane coordinate, but the rest are scaled such that ground distances are used. After shooting the control points the calibration routine returns acceptable results, no more than 0.04′ in the horizontal and 0.03′ in the vertical. I have three points which have are good horizontal and vertical, but the calibration says “Horiz. blunders detected!” and “too few points to check vert.” When I check the “Finish” on the calibration routine it does not do anything, just goes back to the projection screen. These are the only three points I have to go from. Anyone had any such problems?
Log in to reply.