Activity Feed › Discussion Forums › GNSS & Geodesy › PROMARK 500 – GNSS BOARD MISSING ERROR
PROMARK 500 – GNSS BOARD MISSING ERROR
Posted by topo_stremtan on March 11, 2018 at 9:52 amHello. I have a problem with my PM500 receiver. No sattelits are shown. Thanks in advance for any ideea.
brad-ott replied 6 years, 1 month ago 6 Members · 7 Replies- 7 Replies
Had a bad connection to cause that problem and another time it needed a firmware update.
Open the head. There is a gray flat ribbon cable that goes from the main board (green) up to the bucket on the bottom of the antenna (white).
Remove the connector. If you have some contact cleaner, spray some on the end, then put the cable back. Do both ends.
95% of the time, this will fix it.
Mark
and that is why Mark is “the man“
Thank you for the advice. It worked!
FANTASTIC!!!! This is great news.
Another ProMark 500 saved by a simple procedure.
They live another day!
THIS is why this forum exists — so Mark can fix everyone’s probl– er, um, I mean — so everyone can help everyone fix their surveying problems. 🙂 😀
Your friendly, virtual neighborhood WebmasterI love this bar.
Log in to reply.