Community Forums

Community Forums

Problem static data...
 
Share:
Notifications
Clear all

Problem static data, Leica .m00 format  


bundy
Posts: 10
Member
(@bundy)
5+ posts
Joined: 2 years ago

Hi all

I have a problem converting 3 Leica static files into RINEX format.

Background

From a small static campaign spanning two days with two dozen .m00 files generated, 3 of the stations (files) have failed to convert into RINEX format.

Within Infinity 3.2.1 i can view and manipulate the files without issue however when exporting these 2 dozens files into rinex, 3 will not export.

 

I was hoping a member with a more recent version of Infinity could try exporting into RINEX for me.

Thanks

6 Replies
Bill93
Posts: 6783
Member
(@bill93)
5,000+ posts
Joined: 10 years ago

What, if any, error messages do you get?

Was the receiver software the same version for these files as the ones that did convert? If everything used the same software version, then it would seem unlikely an update would fix it.

Was there anything different about those three sessions?

Reply
1 Reply
bundy
Member
(@bundy)
Joined: 2 years ago

5+ posts
Posts: 10
Posted by: @bill93

What, if any, error messages do you get?

No error messages

Was the receiver software the same version for these files as the ones that did convert?

Yes

If everything used the same software version, then it would seem unlikely an update would fix it.

Was there anything different about those three sessions?

No, the previous session and the following session exported into Rinex without issue.

 

Reply
Rover83
Posts: 383
Member
(@rover83)
250+ posts
Joined: 5 years ago

v3.2.1 is not super old, so I doubt that a newer version would make a difference for RINEX export. I too would be interested in the error messages, if any. I have seen Infinity (and some of the controllers) put out some bogus RINEX files in the past.

Have you tried WinTEQC? I use that for most of my conversions or manipulations these days. It will allow you to view the m00 file before conversion so you might be able to see if there is a something going on with the session.

Reply
1 Reply
bundy
Member
(@bundy)
Joined: 2 years ago

5+ posts
Posts: 10
Posted by: @rover83

v3.2.1 is not super old, so I doubt that a newer version would make a difference for RINEX export. I too would be interested in the error messages, if any. I have seen Infinity (and some of the controllers) put out some bogus RINEX files in the past.

Have you tried WinTEQC? I use that for most of my conversions or manipulations these days. It will allow you to view the m00 file before conversion so you might be able to see if there is a something going on with the session.

I have almost no experience with WINTEQC and wouldn't know where to begin manipulating data.

Reply

Stop Fighting WMDC!

Steve Corley
Posts: 797
Member
(@steve-corley)
500+ posts
Joined: 10 years ago

Contact your Leica dealer or call the Leica support line.  Even if you are not under a service contract, this is an issue they should address.  One of the options that I used with Leica GPS was to have them LOG directly to RINEX.  If you load WinTEQC, and select the *.M00 files, if that is one of the supported formats, it will convert the file to RINEX for you.

Reply
vernon14
Posts: 1
Member
(@vernon14)
FNG
Joined: 2 months ago

with the new version shouldn't be a problem

Reply
Scroll to Top