Trimble SNM940 and CB430 cell+GPS
Is anyone familiar with the setup on the SNM940 and CB430 for use in GCS900 machine control? We are setting up the system on a CAT D10R and can’t seem to get VRS corrections from our remote base. The SIM card (ATT-same card used in our TSC3), install and settings were initially setup from our Trimble dealer and we are trying to get those settings along with the service cable to double check everything. We also went through the settings on the CB430 (ver 11.41) and still can’t get any VRS corrections.
Note that we are not using TCC nor are we using IBS from Trimble. Our internet base is simply a static IP which our TSC3’s pickup just fine with no problems.
Just want to see if anyone has any information or experience on this that may help us out.
Artie
Log in to reply.