Polyline Problems in Pocket 3D
I have 2 FC-500’s with almost up to date software. Problem occurs on both.
If I select an entire line with a “box” I get incorrect Target elevations as of a slope grade other than 0% is set (it’s 0% for sure) or a V. offset is set (nope).
If I select a segment and choose to stake out the entire line I get correct elevations.
Measured elevation stays the same; Target and cut/fill differ.
My question is whether it is Pocket 3D, or Magnet Office (which provides the polyline).
My boss doesn’t want to pay to replace both.
Sorry, there were no replies found.
Log in to reply.